Adjustment Programm for P19-1A
===================================

1. Introduction

    Analog flat screen monitors such as the P19-1A must be adapted to the 
    screen controller for each used screen resolution and refresh rate.

    The program LCDADJ.EXE generates the test pattern required for precise
    calibration.

2. Preparation

    Select the screen mode to adjust (e.g. under Windows 9x via 
    Start - Settings - Control Panel - Display - Settings).

    Further information is provided in the operating manual of the monitor.

    Allow the unit to warm up for approx.. 20 minutes prior to calibration.

3. Installing of the driver

    Plug & Play operating systems (Windows 9x / ME / 2000 and XP) ask for a
    driver after connecting the flat screen monitor to the PC and reboot.
    Please follow the instructions of the operating system. On other 
    operating systems please select the screen mode manually.
    
    The optimal resolution for this screen is 1280x1024 and the optimal
    refresh rate is 60Hz.

4. Calibration

    Start the program LCDADJ.EXE.

    The auto adjustment could be performed by the OSD. In most cases
    the result of the auto adjustment is OK.
    
    In seldom cases it is necessary to optimize the image manually:

    In seldom cases a vertical refresh rate higher than 60 Hz would improve
    the picture.

5. Any problem or other question you need clarified?

    Please contact one of our IT Service Shops or your local sales partner 
    or office for advice.
